Use your OBD2 scanner to determine if the trouble code is from the faulty airbag sensor.Your airbag warning light should be off now.

Replace the connectors, the airbag, and the cover of the airbag compartment.

Tighten the steering column using the specified torque.

Replace the steering wheel using the reference painter's tape.

Bend the tab on the new clock spring until it breaks.

Remove the clock spring and replace it with a new one.

Remove the wheel and the nut so you can see the clock spring.

Loosen the steering wheel nut but don't take it out completely.

Mark the steering wheel's position and the steering column with two strips of painter's tape for reference to its alignment. You can move the steering wheel to the left and right so you can remove the connectors easier.

Pull the airbag out and remove the connectors.

Open the airbag compartment by unscrewing the screws that hold it.

Disconnect the negative battery cable and leave it to allow the capacitor discharge.

Make sure that your wheel is straight and that the steering wheel is aligned forward.

Replace the malfunctioning airbag clock strings

Protect yourself and your passenger at all times in case there is a crash. While the airbag may still deploy even if the warning light is on, do not be complacent. The airbag light warning signals you to fix it, so it is safe to drive your vehicle. However, an airbag doesn't also assure your safety. Without an airbag, serious injuries happen when you get into a head-on collision. This force reaches and increases the airbag, thereby protecting the driver on all sides. Next, the SRS system will signal the release of the airbags when it detects a collision.Īirbags commonly use sodium azide, which releases inert and harmless nitrogen or argon gas when ignited with a spark triggered by a collision. When the airbag sensors detect an impending accident caused by a sudden acceleration or deceleration.

Obd2 scanner to reset airbag light